| Step | | Procedure & Parts & Tools |
| 1 |
|
RAISE THE RECOVERY TANK COVER AND LIFT THE RECOVERY TANK UP TO REMOVE IT FROM THE MACHINE.
|
| 2 |
|
LOCATE THE BELT COVER.
|
| 3 |
|
REMOVE THE SCREW HOLDING THE BELT COVER TO REMOVE THE BELT COVER.
| Torx T25 |
|
|
| 4 |
|
LOCATE THE BRUSH DRIVE BELT
|
| 5 |
|
LOOSEN THE TOP BOLT ON THE BRUSH MOTOR. THE BRUSH MOTOR WILL SLIDE DOWN AND RELEASE TENSION ON THE BELT.
| Wrench-metric 10mm |
|
|
| 6 |
|
SLIDE THE BELT OFF THE BRUSH MOTOR PULLEY.
|
| 7 |
|
PULL THE BELT FROM THE BOTTOM BELT PULLEY TO REMOVE IT.
|
| 8 |
|
REVERSE STEPS 1 THRU 7 TO INSTALL A NEW BELT AND TO REASSEMBLE THE MACHINE. MAKE SURE THE BELT IS PROPERLY TENSIONED AND ALIGNED WITH GROOVES ON PULLEYS.
|